TimePilot iButton Locks: Smart, simple, secure

How Does the AccessPilot Software Work?

The process, in a nutshell:
1. Tell the AccessPilot software what changes you want made.		2. Save the changes to the special Program iButton via the Blue Dot Receptor.		3. Touch the Program iButton to each lock to transfer the changes.		4. Touch the Program iButton to the Blue Dot Receptor to let the software know the changes have been made.

CrossOver locks are installed on your doors just like standard locks. The locks are self-contained—no cables or wires to run!

Our proprietary AccessPilot software is installed on your Windows-based computer and the Blue Dot Receptor (shown below) attaches to a USB port on your PC.

Use your software to set up each lock and each employee’s iButton. Each button has a unique ID number, so you can give different employees’ buttons different levels of access. You can set times of entry, specific locks, etc., and track the lock’s use by employee.

When you're done preparing the setup information, just snap your "Program iButton"—an enhanced iButton—into the Blue Dot Receptor and use the AccessPilot software to transfer the lock access data to the iButton's memory. Unsnap your Program iButton from its receptor and touch it to each lock. The iButton setup information is transferred to the lock’s memory.

That’s it—the locks are ready to operate! Want to track the lock’s use? Touch your Program iButton to the lock and plug it into the Blue Dot Receptor at your PC. You’ll see when the lock was used and who used it.

Click here to see screenshots of the AccessPilot software. Want to read the software manuals? They're in the Support Center.

TimePilot Corporation, 340 McKee Street, Batavia, Illinois 60510
Phone: 630.879.6400  Fax: 630.879.8072

Locks Overview    Products   Accessories   iButton Info   Sample Setups   Support Center   Contact Us   Search Site   Home